SELWAY BLACK SLIDE ON LONGBOW QUIVER

This Slide-on quiver fits Traditional Longbows. These quivers are the most permanent quiver that you can take on and off a bow without any tools, screws, or bolts. The Soft-Koat version to be a non-glare soft to the touch molded hood. 

If you are looking for a top quality quiver to complement your bow, then the Selway Archery 6 arrow traditional rubber hood bow quiver is ideal.

Selway's original two-piece slide-on quiver is really simple to install - just slide hood and gripper over the top and bottom limbs of your bow. The Selway quiver is durable, lightweight and very functional.

You can take immense pride in this purely traditional looking, American made tough hood. The rubber hood ensures protection against razor sharp broadheads.

The quiver is absolutely quiet and always stays tight on your bow. It slides firmly over the limbs, holds six arrows securely and is rattle-free and will not interfere with the bow's limb action and provides total fletching clearance.

Goes on and comes off easily and there are no screws or holes to drill. Special limb gripper components are formulated into a rubber compound that will stretch and conform to your bow, providing a perfect fit and will keep your quiver firmly in position. To install, just unstring your bow, remove string and lubricate the slot in the housing with soapy water to facilitate installation of the quiver. Then slide quiver hood and quiver arrow clip over the ends of the bow limbs, ensuring the hood is on the top limb with the hood facing out, away from the sight window. Install the arrow clip on the bottom limb, making sure that the arrow clip is in line with the quiver hood. The hood and arrow clip can be rotated for proper arrow alignment.

Longbow model fits limbs from 1" to 1 3-8" wide. The measurement should be taken at the fadeout section of the limb/riser area of one piece bows. Measure the limb width close to where the limb meets the riser.

Selway rubberised hood slide-on two piece 6 arrow longbow bow quiver.

• Holds 6 arrows securely
• Fits longbows; this may include some of the smaller, narrow limb recurves with longbow type handles
• Hood protects broadheads
• Does not interfere with limb action
• Tough rubber hood
• Quiet and solid
• Fits both right hand and left hand bows
• Simple, durable, ultra lightweight and functional
• Easy on and easy off with no screws, no tape, no holes and no Velcro
• Grippers stretch and conform to your bow's limbs
• Full installation instructions included
• Proudly handcrafted in the USA
• This quiver really complements any lovely traditional bow